Introduction

This is a standard bleach containing 5% available chlorine at the time of manufacture. It has a four-point action plan. It bleaches, disinfects deodorizes and sanitizers. It is ideal for the cleaning and sanitizing of equipment where a longer contact time is required and also as an excellent stain and mould remover. This product may be used in all food type factories where the use of chlorine is suitable.

Advantages

• High Concentration
• Disinfects and bleaches
• Biodegradable
• Free Rinsing
• Broad spectrum sanitation
• SABS 1853 MARK BEARING

Method of Application

 a) For general disinfecting: Clean surface thoroughly with a general detergent and then use Bleach-5H at a dilution rate of 1:100. The product will contain 400ppm of available chlorine at this dilution. If the surface to be cleaned is non-porous, dilute at a ratio of 1:200.

b) This product can be used at lower concentrations for water purification, drain cleaning etc.

Physical Properties

 Chlorine Content:         5% when packed

 S.G.:                              1.1

Colour:                          Light straw

Flash Point:                   None

Odour:                           Typical

Heat Stability:               Stable at room temperature

Toxicology and First Aid

 Caution: This product should not be used on items such as galvanized surfaces and aluminium alloys. Do not mix with acids or acid based products as this will result in the release of chlorine gas.

In the event of skin or eye contact with undiluted product, wash immediately with copious amounts of water and seek medical advice.

The recommendations herein are based on laboratory tests and in field use experiments.  To the best of our knowledge these are accurate and since conditions of actual use are beyond our control, all recommendations are made without any warranty whatsoever.